Fort Canby WWII Radar Site: Difference between revisions
John Stanton (talk | contribs) m John Stanton moved page Fort Canby (2) WWII Radar Site to Fort Canby WWII Radar Site without leaving a redirect |
John Stanton (talk | contribs) No edit summary |
||
| Line 68: | Line 68: | ||
__NOTOC__ | __NOTOC__ | ||
{{PageFooter}} | {{PageFooter}} | ||
{{DEFAULTSORT:Fort Canby | {{DEFAULTSORT:Fort Canby WWII Radar Site}} | ||
[[Category:All]] | [[Category:All]] | ||
[[Category:Washington All]] | [[Category:Washington All]] | ||
Revision as of 07:58, 3 June 2017
|
Fort Canby WWII Radar Site (1943-1946) - A World War II U.S. Army Radar Site established in 1943. Used to provide fire control information to large caliber (6" and above) coastal gun batteries in the Harbor Defense of the Columbia against enemy warships. Located on Fort Canby, Pacific County, Washington. Closed in 1946.
HistoryPart of the Harbor Defense of the Columbia.
 Constructed under project No. RAD 9-1012 and transferred for use on 1 Apr 1943 as Fort Canby Radar Site. Construction costs to date of transfer were $7,974.37. The physical plant consisted of a transmitter building, two power houses each with a 1000 gallon fuel tank, a 25' steel tower and a antenna housing disguised as a Water tank atop the tower. The three buildings and the tower were prefabricated steel units furnished by the Signal Corps. The buildings and the tower were placed on concrete pads and footings installed by the Corps of Engineers who erected all of the structures. Access to the antenna on top of the tower was by a small hoist operated by an electric motor. The engineering construction work was done by government forces who started on 9 Jul 1942 and finished on 31 Jan 1943. The radar equipment was installed by the Signal Corps. It required 16.3kW of 120/240 AC, 1 phase, 60 cycle power furnished by commercial power backed up by the two on-site generators. The two 25 kW generators were furnished and installed by the Signal Corps. The commercial electrical power furnished under the initial project proved inadequate to power the radar site which required 16 kW for the radar equipment. A supplement to the initial project added an electrical pole line from the base commercial power lines to the radar site electrical switching mechanism. This was described as 800' of pole line and 150' of underground cable. The pole line carried 2300 volts, single phase phase, over No. 6 bare hard drawn cable to a 15 KVA transformer at the end of the pole line. From the tranformer 110 volts, single phase, was carried underground on two No. 4 lead covered cables into the transmitter building. The supplemental power project cost $1,814.23 as of the date of transfer on 21 Jun 1944.  The drawings for the supplemental power project show a small cluster of buildings attached to the new pole line near where it connects to the main post power line. This may have been the cantonment area for the radar site.
Site Operation  In operation, the SCR-296A radar could only track one target at a time. Target assignments were made from the harbor HECP/HDCP command posts by telephone, citing the approximate range and azimuth of the target. The SCR-296A radar operators would then find the target and pass the precise range and azimuth to the plotting room at the gun battery by phone. Two operators were required, one for the range position and one for the azimuth position. The radar operators would continue to track the target and update the plotting room as the range and azimuth changed. The Radar track data for this site was provided by telephone to Battery 247 as the primary battery and to secondary batteries including Battery 245 and Battery 246. Battery 247 was a 6" gun battery located on Fort Canby. The SCR-296A Radar equipment was declared obsolete by AG letter on 17 Jan 1946. The Tower and radar equipment were to be disposed of while the buildings were to be retained.
ClosureClosed in 1946. Current StatusNo remains.
See Also: Sources:
Links: Visited: No
| ||||||
